Z4-forum.com

It was discussed on another post. Give me a minute and I'll find it.

This topic http://www.z4-forum.com/forum/viewtopic.php?f=2&t=25453
Post no.3
I can also recommend joe from Sopers of Lincoln (great service)
If you install this can I have a picture of before and after as I am also thinking of fitting

Daaaavvveee wrote:

TomHitmanHatton wrote:I ordered mine from this company. I think it was this set http://www.ebay.co.uk/itm/8-XENON-WHITE ... 3ccfa1a559

Just ordered them, the license plate LED ones, you say a special holder is needed? Any idea on part? Thanks

If you get the ones on the left, the 8 SMD ones you just use the existing bulb holder, no special holder required.

Just pull out the old halogen bulbs and replace with LED. The centre lights are tricky to get out.

The license plate needs a special housing

Give me a minute and I'll do a picture

Hardest thing in the world to picture at night haha. You don't really see them to honest but the light they give off are very pleasing to the eye

Best I can rustle up

TomHitmanHatton wrote:Just pull out the old halogen bulbs and replace with LED. The centre lights are tricky to get out.

The license plate needs a special housing

As per my post above, no special housing if you buy the right LED's

Is there a guide anywhere on how to get the damn housing from the central windscreen light out?

TomHitmanHatton wrote:Hardest thing in the world to picture at night haha. You don't really see them to honest but the light they give off are very pleasing to the eye

I put the ceiling of 3.0. It is the same as yours and I put the LEDs. Only problem is that the fading has been lost a bit. So I put the old bulb.

I haven't had any issues with fading

To me it does fade until mid then turns off suddenly uff

Changed all my bulbs now apart from the dome above the gear knob

I had it off but the leds are too big to fit in the hole (ooo arrr!) so was wondering if anyone had any techniques or tips? Or is it simply a case of ordering different leds lol

theres two phillips screws on the back of the lamp unit to remove the perspex part of the light, remove these insert bulb inside crystal part and reinstall perspex.

I've got the unit off now and can't see any screws?